Web Guiding Accessories: Custom Solutions for Reliable Web Guiding

Configured to your production: BST eltromat web guiding always conforms precisely to the demands of your production processes in terms of their extent and degree of automation. The variety of connected BST eltromat components guarantees an optimal adjustment to the requirements of the specific task. We offer you the following accessories, among other things:


CAN2 Ethernet Coupler (C2E Coupler)

The CAN-2 Ethernet coupler allows for an intelligent networking possibility for the BST eltromat ekr 500 digital control amplifier and the ekrPro Com60 series. With the help of a C2E module, up to four ekr 500 digital control amplifiers can communicate with the superordinate machine control. Additional networking is possible with the integration of additional C2E couplers.

The BST eltromat C2E module uses the BST eltromat internal CAN bus and function as a gateway to the superordinate machine control. Your benefit: The internal communication of the controllers among themselves is not disturbed by additional traffic or slowed down in its performance.

Electronic Fine Adjustment (EFE)

Due to either the conditions of the machine or production requirements, it may be necessary for the web position to be corrected at a location remote from the guiding device. Electronic remote operation permits correction of the web position, and the operation and visualization of basic functions from any place in the machine.

Electric Motor-Driven Sensor Positioning

If the location of the sensor is difficult to access or if the scanning position must be frequently changed due to various web widths, a sensor positioner (FVG) takes over the adjustment of the sensor position. Depending on your needs, various automatic systems with electromechanical motor-driven actuators are available.

FVGPro 1/K; SP/K-1 Sensor Positioner

The simplest electromotive operation of the sensor positioner allows for the positioning of a sensor. It is used for web edge guiding.

FVGPro 1/MK; SP/MK-1 Sensor Positioner

This variation allows for the simultaneous positioning of two sensors. It is used for web center-line guiding with a set web center. The position of the sensors is adjusted symmetrically to the center of the web via an actuator.


FVGPro 2/MK; SP/MK-2 Sensor Positioner

These sensor positioner have two sensor mountings and two separate actuators. This enables both sensors to be adjusted independently of each other. The device is used for web edge guiding and web center-line guiding. Through synchronous control of the actuators, digital web shifting is possible across the entire area. They are also well suited to off-center, narrow webs.